Complete Nostalgia Dragster |
- Complete 225" tig welded 4130 condition "n" chassis, meets S.F.I. specs
- Complete A arm front end with slip fit suspension
- S.P.E. billet aluminum spindles. 4130 available
- Tow hooks on spindles
- C.N.C. polished steering bell crank
- S.P.E. billit aluminum steering box
- Complete steering linkage with rod ends and tie rods
- Ultralite butterfly dragster steering wheel with quick connect
- Ultralite composite dragster nose
- Front ballast mounts
- Fuel cell
- Fuel cell mounting tray
- Battery mounting tray
- Battery hold down and ground stud
- Master cut off switch mount
- Front moter mounts with saddle tabs and clamps. 6063 T 6 aluminum
- Rear moter plate with saddle tabs and clamps 6063 T 6 aluminum profile milled
- Engine travel limiter
- Motor plate chassis uprights with 5/8 rossette tubes, 3 per side
- Complete hand formed "Newstalgia" shorty style body
- Aluminum floor pan with tunnel
- Aluminum or lexan windshield
- 6 point cage with helmet bars
- Helmet hook on cage
- Driver assist entry and exit tubes
- Ultralite composite seat
- Brake pedal or handle
- Master cylinder mount and linkage
- Reinforced brake line chassis slots
- Brake line bulkhead tabs
- Throttle pedal with adjustable stop
- Throttle pedal cable mount with hardware
- Polished aluminum dash
- Switch panel for starter button, and toggle switches
- Electronics panel, forward of dash
- Reinforced wiring slots
- Seat belt mounting tabs
- Shifter mounts
- Parachute lever with cable mount and hardware
- Shifter mount
- Front and rear wing mounts
- 9 in.ford housing with 4130 tubes
- Big bearing ford or olds C.N.C.ends
- Filler cap ,drain plug on housing
- Pinion support, and anti rotation device, built tl S.F.I. specs
- Grade 8 fasteners on complete chassis assembly
- Manufacturer’s tag
- Customer ID Tag
|
 |
|
